Visible belt damage is a reason to investigate. Noise, poor cutting or loss of movement can also involve other components, so use symptoms to guide inspection rather than to diagnose the belt alone.
Inspect the belt surface
With the machine isolated and access made safe, look for damaged edges, exposed cords, missing material, cracking or a polished surface. Photograph the damaged area. Do not reach towards a moving belt or run the mower with guards removed to watch it.
Connect wear to its location
Damage concentrated on one edge may point to rubbing or alignment trouble. Localised burning or repeated damage at the same point warrants a pulley and tensioning check. Replacing the belt without correcting the contact point may sacrifice the new part.
Treat symptoms as clues
Squealing, slipping or a burning smell can accompany belt problems, but bearings, obstructions or an incorrect load can also be involved. Stop using the mower if the belt is smoking, shedding material or repeatedly coming off. Arrange inspection before further operation.
Record the replacement details
Use the machine plate and parts diagram to identify the belt, keeping the old part and markings until the replacement is confirmed. Note the hours or date and any repaired components. This gives useful evidence if wear returns unusually quickly.
Common question
Should I replace a belt just because it is old?
Follow the manufacturer’s inspection and replacement guidance; age alone does not establish its condition.
Find the right replacement
Use the confirmed machine and part details to narrow your search. Check the individual listing before ordering.